|
S40 / V40 '96-'04 General Forum for the Volvo S40 and V40 (Classic) Series from 1995-2004. |
Information |
|
Guide: How to change oil, oil filter & fuel filter.Views : 35224 Replies : 29Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Feb 25th, 2012, 16:16 | #1 |
Master Member
Last Online: Dec 30th, 2018 08:33
Join Date: Oct 2010
Location: Craigavon area
|
Guide: How to change oil, oil filter & fuel filter.
For S40 Phase2 year 2003 TD 115 HP (Renault engine)
For those who wants to service their own cars. Tools you will need: Axle stands X2 A car Jack Oil filter + engine oil Diesel filter insert Oil filter wrench (comes in all shapes and sizes, I used the basic one) A wrench for draining oil from the sump. Make sure you got everything you need before you start doing all this. So then: Run the engine for about 2-3 minutes from cold, no more than that. Make sure your the engine is cool enough to touch with your palm, otherwise you might get burns from the hot engine oil. Leaving your engine running for those 2-3 minutes should be enough to make oil flow more faster and freely. 1. Jack up the car. 2. Make sure that axle stands are secured and that there is enough room for you to get under the car. 3. Remove engine cover ( I don't have it so I am skipping this one) 4. Locate a engine oil drain plug under the sump (It should be in the middle of sump) 5. Use something to catch the old oil (oil pan for example) Note: Put some old peace of cloth or newspapers under car, its in case if the oil doesn't want to go where you tell her to go. Meaning less mess at the end when you have to clean up all the oil spills/drips. 6. Wait until the engine oil has stopped dripping often than 1 drip per 3 seconds. (basically when there is no oil left in the sump ) 7. Some say that you HAVE TO use a new washer when you tighten the oil drain plug, I say: you can use the old one. So make sure you install the oil drain plug back in place and that it won't come loose, but do not over tighten it. 8. Remove the oil pan with the old engine oil from underneath the car. Oh look, its a black gold!!! The same stuff why some countries go to war with other less advanced countries Make sure you dispose of it properly! For comparison: Fresh engine oil on the left, used engine oil on the right. its just ~9000 miles difference. 9. Remove the engine cover (if you have one) 10. Put some kitchen towels underneath the old oil filter housing. and get ready to remove the old oil filter. 11. Watch the video. I didn't know how to use this type of oil wrench at first, but after some low quality youtube videos I have mastered this skill [YOUTUBE]http://www.youtube.com/watch?v=m5ist...1&feature=plcp[/YOUTUBE] http://www.youtube.com/watch?v=m5ist...1&feature=plcp (if video doesn't work) Yes, this is my first HD video on youtube and everywhere else. You might want to watch it on full screen. but then I realised that I didn't put a peace of cloth under the oil filter properly and the engine oil which was inside the oil filter managed to escape... make sure you do not make the same mistake. 12. Clean the filter housing. 13. Get you brand new oil filter and apply a thin layer of a NEW engine oil to the NEW oil filter gasket, and pour a little bit of engine oil inside the filter itself. [YOUTUBE]http://www.youtube.com/watch?v=J6roL...6aAUAAAAAAABAA[/YOUTUBE] again in full HD... 14. Put a kitchen towels under the oil filter housing and screw the oil filter in place. Note: Hand tighten only, you should NOT be able to unscrew the oil filter once you have it installed! And all you need to do next is fill it HALF WAY with new engine oil, run the engine and check for leaks around the oil filter and under the car around the oil drain plug. I use simple funnel to add the engine oil, By the way, I remove the crankcase ventilation hose to speed up the oil flow a bit. Check the engine oil level next time when you want to go somewhere, top up if necessary. Changing diesel/fuel filter. Tools that you will need: A new filter with 2 new gaskets (should come in one box) A torq type wrench. Size 10 spanner/socket 1. Remove the fuse box bolts X2. looks like this Note: be extra careful not to damage any relays or wiring. 2. Undo the bolt for the filter cap Drain the fuel. There is a small bolt that looks like this the same type is used for bleeding callipers, if you are familiar with this type you will know what to do. To unscrew it you need to rotate it CLOCKWISE. Move the top part towards the turbo. Now you can see the old fuel filter. remove it, it should come out easily. I had to remove the whole fuel filter housing so that I could clean it, now I know how and why fuel pump and/or injectors cease to work... (about that, I will post a video later on next week) 3. Remove the old gasket, make sure that everything is clean underneath the gasket. 4. Install new gaskets. Note: smallest one goes onto the long bolt that you had to remove on step 2. 5. Install the new filter. 6. Make sure that you tightened the bleeding bolt underneath fuel filter housing. Do not over tighten it. 7. Put the top part of fuel filter back on and tighten the bolt. 8. Pump the manual diesel pump around 3-4 times or until it gets hard, make sure that there is no leaks. If you are pumping and it doesn't get hard, then you most likely forgot to install the new gasket between the top part of fuel filter and the housing itself. 9. Install the fuse box back in place. 10. Start the car. Rpms could go between 500-1200, it should be like that for few seconds, if it doesn't stop, then just rev the engine slightly. it should go back to normal. And that's you finished. Time wise it took me 4 hours, but it is including two short brakes, removing the whole filter housing, cleaning it and making sure that everything is fine. Old VS New Mann filter on the left, OEM filter on the right.
__________________
Useful threads and information Guide: How to change/adjust timing belt Guide: Fitting LED's This is how S40 1.9 TD engine components looks like Information regarding EGR, problems and solutions A.K.A. Hesitation, sluggishness etc. Last edited by Biotoxic; Feb 25th, 2012 at 16:45. Reason: Fixed youtube links, changed name, added pics |
The Following 18 Users Say Thank You to Biotoxic For This Useful Post: |
Feb 25th, 2012, 16:35 | #2 |
Idiot
Last Online: Apr 21st, 2019 17:29
Join Date: Nov 2006
Location: Derby
|
i see your car has the suspension tie bar that i only thought the T4's have.
__________________
Vectra VXR estate convert Experience = V40 1998 2.0 CD lots of mods Busy pestering the poor sods here now |
Feb 25th, 2012, 16:40 | #3 |
Master Member
Last Online: Dec 30th, 2018 08:33
Join Date: Oct 2010
Location: Craigavon area
|
It's a Sport model, maybe because of that.
__________________
Useful threads and information Guide: How to change/adjust timing belt Guide: Fitting LED's This is how S40 1.9 TD engine components looks like Information regarding EGR, problems and solutions A.K.A. Hesitation, sluggishness etc. |
Feb 25th, 2012, 17:36 | #4 |
Premier Member
Last Online: May 2nd, 2018 08:14
Join Date: Sep 2011
Location: DownSouth
|
Excellent guide and the only thing worth adding is that as the 1.9D holds 5.6 ltrs of oil, so you just need to add the 5 ltr can and then top off after the next trip.
The best oil according to both Volvo and the oil companies is a 5/40 fully synthetic that meets all the specs. The handbook gives other viscosity ratings but the pro's use 5/40 as an all season rating. The oil change interval in the book is either 15,000 or 20,000 km according to the exact year, which in my opinion is nuts, so I just use 10,000 km (6,000 miles) for oil and filter changes, although the fuel filter is normally good for 20,000 km plus. |
The Following User Says Thank You to skyship007 For This Useful Post: |
Feb 25th, 2012, 20:35 | #5 |
Member
Last Online: Dec 3rd, 2014 18:22
Join Date: Nov 2011
Location: paraparaumu new zealand
|
hey , nice article.....where can i buy one of those fancy looking funnels?
__________________
1998 s40 1.8 auto (silver) Volvo motor |
Feb 25th, 2012, 20:38 | #6 |
Senior Member
Last Online: Sep 23rd, 2014 20:55
Join Date: Apr 2009
Location: accrington
|
nice one biotoxic. i've serviced my own 02 reg diesel 3 times now, and i think it's the easiest car i've owned to service. the air filter is very easy as well.
__________________
if it's got t#ts or wheels, i've had trouble with it! |
The Following User Says Thank You to jez v40 For This Useful Post: |
Feb 25th, 2012, 20:41 | #7 |
Senior Member
Last Online: Sep 23rd, 2014 20:55
Join Date: Apr 2009
Location: accrington
|
blairs 40. you don't need to buy one, just wait until recycling day, you can find them littering the streets.
__________________
if it's got t#ts or wheels, i've had trouble with it! |
Feb 26th, 2012, 12:46 | #8 |
Premier Member
Last Online: Jul 24th, 2015 16:09
Join Date: Sep 2008
Location: oxford
|
Ask a friendly cider drinker if you can have the bottle when he has finished?
|
Feb 26th, 2012, 16:31 | #9 |
Master Member
Last Online: Feb 10th, 2022 10:02
Join Date: Jun 2011
Location: THE MINSTER MAN
|
service
nice thread biotoxic,could you tell me where to pump the manual fuel pump,and what should i use to clean the fuel filter housing out with.and do i have to put 5.6ltrs of oil in should i change the air filter,even if its clean...thanks volvo v40 1.9 td estate 2003
Last edited by neanderthal; Feb 26th, 2012 at 16:39. |
Feb 26th, 2012, 16:52 | #10 |
Senior Member
Last Online: May 31st, 2024 17:28
Join Date: Dec 2008
Location: Malton
|
Thanks for the guide, finally gave me the courage to change the fuel filter. Took a lot of pumps to get the pressure in built up at the end!
Cheers Phil
__________________
2002 V40 1.9D SE, 218k miles 2002 V40 1.9D S 200k miles, for spare parts and storing things in! |
The Following 2 Users Say Thank You to phil_r For This Useful Post: |
Tags |
diy, fuel filter, oil change |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|