Should I replace these engine mounts?

[360beast]

Originally Posted by classicswede

It does seem PPS are the only place you can get rubber mounts from and what I stock.
Poly mounts are fine if you drive the car but if you spend a lot of time sat in traffic then the bit of vibration you get at tick over is likely to become irritating

I think they might be the solution then as my 940 is purely for fun.

[Gotcha]

Yeah time to change. Go through all of them and change everything once.

[Rversteeg]

Being in Portugal I do not think that TS will buy his parts in the UK, since it a terrible hassle to get your stuff through UK customs since Brexit. Luckily there are plenty of suppliers available outside the UK, especially in The Netherlands, Germany and Sweden. I am sure that Salvador will know where to find them using p/n 1378657.
Do not expect a hugh difference though; I changed the mounts on my 940LPT after 500K km and I could hardly feel any improvement, if at all. Either the aftermarket stuff is of lower quality or the OEM ones just last very long.

[baggy798]

Apparently 2wd Sierra Cosworth engine mounts fit. They look very similar.



https://www.burtonpower.com/catalogs...gine+mount+2wd

Definitely don't want poly or hockey puck mounts for the road.

https://passionford.com/forum/ford-s...ne-mounts.html