|
300/66 Series General Forum for the Volvo 340, 360 and 66 cars |
![]() |
|
Draining cooling systemViews : 1276 Replies : 2Users Viewing This Thread : |
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Guest
Location:
|
![]()
I own an H Reg 340 1.7 GL. I need to replace the hose that runs between the expansion tank and the radiator because its currently leaking. I thought that whilst I'm taking this hose off, I might as well drain the system and fill it again.
I've been told that this model operates a self contained cooling system, so theres no drain plug on the radiator. I assume that I need to take the bottom hose off of the radiator in order to fully drain the system. Before I start.... I just wanted to check that this is correct! Is the hose that I need to take off the one directly below the hose that runs to the expansion tank? (Bottom right hand side of the radiator... if looking back to front) Any help would be appreciated, Rob |
![]() |
![]() |
#2 |
Forum Support Team
Last Online: May 28th, 2024 10:43
Join Date: Jan 1970
Location: Glasgow, London
|
![]()
yep, the very bottom radiator hose. Make sure you put the heat control to max. When you refill, just refill through the expansion tank till at max. Start up and run with the cap off and top up if the level drops below max, until the engine is completely hot. Ie thermostat open. Check the interior heater is operating correctly the switch off.
You need to re top after the engine has cooled cos the level will have dropped. Andy |
![]() |
![]() |
![]() |
#3 |
Guest
Location:
|
![]()
Thanks Andy, much appreciated.
- Rob - |
![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|