|
S80 '98-'06 / S60 '00-'09 / V70 & XC70 '00-'07 General Forum for the P2-platform S60 / V70 / XC70 / S80 models |
Information |
|
Accessing fuel float (Rear nearside )Views : 465 Replies : 9Users Viewing This Thread : |
|
Thread Tools | Display Modes |
|
Nov 12th, 2021, 19:35 | #1 |
I've Been Banned
Last Online: Dec 16th, 2021 22:41
Join Date: Oct 2021
Location: london
|
Accessing fuel float (Rear nearside )
How to access the fuel float sender .Under the white plastic cover with electrical connector . Not the pump side that has the teeth ring etc . Want to access and check .But No youtube video shows how to remove the cover ! Ive removed the metal cover but wont attempt the plastic until i have a clue
|
Nov 13th, 2021, 01:59 | #2 |
Premier Member
Last Online: Yesterday 08:25
Join Date: Feb 2012
Location: Preston
|
It’s a special tool..
However I used 2 very big screwdrivers braced against each other to shift the locking rings. You may snap some of the plastic teeth off though as it needs a lot of pressure to shift them. Both sides are the same btw. Have you read the float levels with vida to see what’s going on? Oh, and don’t try and do it until the tank is low or the fuel level is higher than the access hatch. |
Nov 21st, 2021, 15:42 | #3 |
I've Been Banned
Last Online: Dec 16th, 2021 22:41
Join Date: Oct 2021
Location: london
|
Still have not accessed the WHITE plastic cover that is on the FLAT section under the passenger seat .NOT the other one sat higher up on the drivers side rear . Ive read somewhere that some people have managed to get a better result just by rotating the arrow point a few mm left or right. Today the car ( I was testing it for this reason) stuttered when starting and showing 60 miles of petrol left. last time it did it is showed about 110 miles left . Once the car became level after coasting down the road. It all started fine and i put 1/2 a tank of fuel in etc
|
Nov 22nd, 2021, 14:24 | #4 |
Premier Member
Last Online: Yesterday 08:25
Join Date: Feb 2012
Location: Preston
|
Just get one of these, should do the job.
https://www.machinemart.co.uk/p/lase...E&gclsrc=aw.ds |
Nov 22nd, 2021, 17:54 | #5 | |
I've Been Banned
Last Online: Dec 16th, 2021 22:41
Join Date: Oct 2021
Location: london
|
Quote:
Last edited by JJD1; Nov 22nd, 2021 at 17:57. |
|
Nov 22nd, 2021, 17:56 | #6 |
Premier Member
Last Online: Yesterday 08:25
Join Date: Feb 2012
Location: Preston
|
It shouldn’t be, can you put a picture on of what you mean?
I did the job on a P2 and both locking rings are the same. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|