S80: Gearbox CV Joint

[dped]

CV joint (drivers side) need replacing on my 2010 XC70 205bhp. Looked on youtube and searched other guides but can't find CV or drive shaft replacement on later models.

I've done a CV joint on a 2003 P2 V70, simple knock it off with a hammer while been carful not to knock the complete drive shaft out. Then replace the clip and knock the new one on again (tip used a section of 3X3 timber with hole drilled in the end which fits over the shaft to protect the shaft end from mushrooming while hammering it on)

So question, Is the CV joint the same on 2008on XC70's as P3 V70 ? or do I need to replace the complete drive shaft ? if so does the complete drive shaft just slide out of the gear box (with a little help) or is there a bolt holding it in place ?

Thanks in advance