PCD adapters

[Antz]

Originally Posted by Thumperslaw

Great thanks for the info. My wheels are 16 inch 7.5j. Think the offset was 42.
Did you trim the hub studs down?

I didn't have to with my wheels but my mate did. It depends on the back of your wheel. His are flat so caught the wheels dn needing trimming whereas mine have little pockets and didn't.

[craicedup]

i run 5x 108 to 5x 114.3 on my glt ..32mm on rear 27mm on front 17 inch work nezarts et 50 ..zero rubbage think their 9j need to check

regards
dec

[Thumperslaw]

Originally Posted by Antz

I didn't have to with my wheels but my mate did. It depends on the back of your wheel. His are flat so caught the wheels dn needing trimming whereas mine have little pockets and didn't.

Unfortunately mine are flat. Would 30mm spacers clear the hub studs? Ideally I’d like to stick at 25mm. Am happy to trim the studs if need be.

[Antz]

Originally Posted by Thumperslaw

Unfortunately mine are flat. Would 30mm spacers clear the hub studs? Ideally I’d like to stick at 25mm. Am happy to trim the studs if need be.

Yep 30mm will clear. Its only the 20s which wont and they only catch marginally. Trimming them down solves the issues on 20s.

[Thumperslaw]

Originally Posted by Antz

Yep 30mm will clear. Its only the 20s which wont and they only catch marginally. Trimming them down solves the issues on 20s.

Thanks, about to order some this week. Be nice to have my borbet wheels fitted.