Amazon: Boot springs - any options?

[samaron]

The boot lid on my Amazon would barely stay open on its own when I got the car. After registration and mounting the license plate, it gave up completely. I'm not sure how common of a problem this is.

I bought some new torsion bars and made up a tool based on some vague pictures I found on a different forum. Removing the old bars were fairly easy, and the ends were offset from each other. Probably why there were no tension left in the lid.

Installing the new bars have been seemingly impossible. During the installation attempts there have been said things that I'm not proud of. Eventually it was realized they're not identical to the old ones. The general shape is there, but the bends are a few millimeters off, which causes problems. Attempts have been made to manipulate and tweak the bars in a vise. It's close, but still doesn't fit. It hooks into the lid hinge now, but the L on the other end is impossible to get into the hook in the body. Had a friend over today where we both wrestled with it, and eventually gave up.

Are there any alternative options available? Does anyone sell coil springs, gas struts or other solutions for Amazon? I just want my boot lid to stay open on its own without the need for a broom shaft.

[Ron Kwas]

Sam;

Often, reposition the Torsion Springs into their second preload position with the SVO 2572 Tool brings back the necessary force to help keep the lid open...

See also: https://www.sw-em.com/Trunk-Lid%20To...ng%20Notes.htm

Good Hunting!

[samaron]

Another excellent article. Thank you, Ron!

Unfortunately my springs were in the second position, which is why I chose to buy new. Didn't appear to be any further way to increase the tension.

20240827_183432.jpg

The upper one is the new spring. As mentioned, the general shape is there, but it isn't the same. The bends are not as sharp, and this part is also 5 mm wider. It didn't fit into the slot where it pivots. In the picture I have already tweaked it a bit, but still have fitment problems. We managed to get it into the pivot slot after some force had been applied, but were unable to hook it into the body on the other end. We pulled on the rod in order to retract it, but couldn't get it into place with my interpretation of the SVO2572 tool. We just couldn't retract it enough for it to swing into place.

I were hoping some company were making kits with a different and more installation friendly solution. The new springs from VP just aren't good enough quality.

[Simmy]

some owners have fitted gas struts be very careful as its very easy to injure your self with these types of tension bar springs.

[samaron]

Were hoping some company made a gas strut retrofit kit or similar. I've seen struts advertised for Amazon, but no fitment hardware is provided. Probably just automatically generated based on my search query. This does make me think it isn't a very common problem with relaxed torsion bars. Perhaps I've been very unlucky with my car.

If anyone has retrofitted gas struts, what hardware were used and what were the specifications of the struts? Where was the fitment hardware attatched in order for the strut to operate properly?

[classicswede]

It is a very common issue.

I have seen more tension added by putting a flat plate through where the rods cross each other.