|
140/164 Series General Forum for the Volvo 140 and 164 cars |
Information |
|
Propshaft Bearing and Mount 164Views : 906 Replies : 2Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jan 3rd, 2022, 18:13 | #1 |
New Member
Last Online: Jan 16th, 2022 19:47
Join Date: Jan 2022
Location: Luton
|
Propshaft Bearing and Mount 164
Hi and thank you for allowing me into the forum.
I have recently acquired a 1969 3.0 litre non fuel injected 164. I have already replaced both rear callipers, hoses, clutch slave cylinder and hose and exhaust brackets. The rear brake on one side was binding and it ended up being a collapsed flex brake pipe. The clutch pedal was really stiff and only returned slowly and again this was down to a collapsed flexi hose. I have a knocking when accelerating sometimes and it is coming from under the floor around the middle of the car. From looking at the Propshaft rubber mount there is a lot of play and I can push and pull the propshaft easily about inside the rubber. I suspect the mount needs replacing so will be doing that and the bearing whilst I am at it. Can anyone shed some light as to how easy it is to separate the two shafts so I can get the old mount and bearing off please ? |
The Following User Says Thank You to minty1084 For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|