Kick panel and under dash clips - what am I missing?

[ie940]

Don't suppose anyone can describe what i appear to be missing? Interior has been out 6 months chasing leaks and not entirely sure it was complete to begin with.

1. The drivers side kick panel over the ECU doesn't appear to have anything holding it on. Is there supposed to be some sort of gripper clip on the back of it?

2. Both sides under dash trims aren't supported where they meet the kick panels. Is there supposed to be a little L bracket or similar joining that corner?

Thanks

[griston64]

Originally Posted by ie940

Don't suppose anyone can describe what i appear to be missing? Interior has been out 6 months chasing leaks and not entirely sure it was complete to begin with.

1. The drivers side kick panel over the ECU doesn't appear to have anything holding it on. Is there supposed to be some sort of gripper clip on the back of it?

2. Both sides under dash trims aren't supported where they meet the kick panels. Is there supposed to be a little L bracket or similar joining that corner?

Thanks

I think its 3 or four torx head screws at the top and a twist screw on the right hand side lower down

image below is obvs from a L/H drive car

[baggy798]

This one?



It slides into the metal of the ECU cage, remember to bend the very top of it under/behind the A pillar trim first. Then finagle it under the rubber strip that runs along the door jam, at the same time pushing it sideways into a green clip.

The under dash trim slides into a trim clip as depicted by my excellent drawing. There's a white plastic thing that it slides into on the heater/clutch pedal side too.