|
700/900 Series General Forum for the Volvo 740, 760, 780, 940, 960 & S/V90 cars |
Information |
|
Morning sickness, wandering a bit, PAS woes.Views : 1188 Replies : 29Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Oct 25th, 2021, 18:12 | #1 |
Member
Last Online: Nov 26th, 2022 15:34
Join Date: Sep 2019
Location: BRISTOL
|
Morning sickness, wandering a bit, PAS woes.
I had an issue back in the spring where my steering was quite stiff first thing in the morning (especially turning clockwise / right) from centre which seemed to go away with the warmer weather.
Since the overnight temps have started dropping its back! I have replaced the PAS fluid with the prescribed ATF, but didn’t manage to get it coming out red… no matter how much I siphoned out and replaced then pumped through it still comes out murky grey. Of note, when turning the wheel it feels like there’s a point when I pass a notch and the wheel suddenly comes free, it’s hard to explain I’ve noticed that my steering is a lot more wandering and sloppy at the moment (once the stiffness has gone after a couple of turns, or the oil has warmed up). Is a new / rebuilt rack in order? Last edited by StrongSpearWorks; Oct 25th, 2021 at 18:26. |
Oct 25th, 2021, 20:23 | #2 |
Master Member
Last Online: Today 09:44
Join Date: Nov 2012
Location: London and Cambridge
|
Start by spraying the two universal joints in the steering column (under the bonnet) with the penetrating spray of your choice twice a day for a week and see if it gets better.
Cheers |
The Following 2 Users Say Thank You to Bugjam1999 For This Useful Post: |
Oct 25th, 2021, 20:58 | #3 |
Member
Last Online: Nov 26th, 2022 15:34
Join Date: Sep 2019
Location: BRISTOL
|
I’ll give that a go…
|
Oct 25th, 2021, 21:42 | #4 |
Senior Member
Last Online: May 8th, 2024 21:21
Join Date: Nov 2018
Location: Reading
|
This has worked for mine. First thing it’s really stiff turning right but eases up after a while. Keep spraying the joints, and maybe looks to something more thicker to keep the joint from getting dry.
|
The Following 3 Users Say Thank You to Challo For This Useful Post: |
Oct 25th, 2021, 22:20 | #5 |
Member
Last Online: Nov 26th, 2022 15:34
Join Date: Sep 2019
Location: BRISTOL
|
I’ll give everything a go it means not replacing the rack 🤣
|
The Following 2 Users Say Thank You to StrongSpearWorks For This Useful Post: |
Oct 25th, 2021, 23:37 | #6 |
Premier Member
Last Online: Today 10:45
Join Date: May 2012
Location: Lakenheath
|
You could also try replacing the fluid, empty the reservoir with a large syringe (~200ml) and discharge it into an empty, clean Pot Noodle pot or similar - makes it easier to see the colour and contamination.
Refill with ATF and bleed by turning the wheel from lock to lock slowly with the engine idling. Top up if necessary after. Repeat this weekly (assuming you're using the car) until the fluid stays clean. If it doesn't even begin to get clean, you'll have to find the cause.
__________________
Cheers Dave Next Door to Top-Gun with a Honda CR-V & S Type Jag Volvo gone but not forgotten........ |
The Following User Says Thank You to Laird Scooby For This Useful Post: |
Oct 26th, 2021, 06:35 | #7 |
Member
Last Online: Nov 26th, 2022 15:34
Join Date: Sep 2019
Location: BRISTOL
|
I’ve pumped two litres of fresh ATF through the system and it still comes out grey. Any ideas what could be contaminating it? I’m thinking degrading seals perhaps… I’m not leaking any fluid. The rack is dry at all the exit points and the level is steady.
|
The Following 2 Users Say Thank You to StrongSpearWorks For This Useful Post: |
Oct 26th, 2021, 09:41 | #8 |
Premier Member
Last Online: Today 10:45
Join Date: May 2012
Location: Lakenheath
|
It could be the pump causing the contamination, if it is excessiely worn. It will also be noisy and you will likely be able to feel some play on the pulley. The rack could also be worn, also the strut top bearings could be shot causing the stiffness, the UJ in the column could also be excessively stiff, it sounds as if you may have more than one problem contributing to the woes.
__________________
Cheers Dave Next Door to Top-Gun with a Honda CR-V & S Type Jag Volvo gone but not forgotten........ |
The Following User Says Thank You to Laird Scooby For This Useful Post: |
Oct 26th, 2021, 10:57 | #9 |
Master Member
Last Online: Today 09:44
Join Date: Nov 2012
Location: London and Cambridge
|
When I swapped the fluid on my power steering first I jacked up the front of the car and supported it on axle stands with the front wheels free, then I removed the PAS return line and put that into a white washing up bowl from Poundland under the car (I extended it with a suitable piece of hose) - the bowl needs to be white to see the fluid colour.
Then I got a willing volunteer to start the car and spin the steering wheel lock to lock, whilst pouring new fluid into the PAS reservoir (it goes down fairly quickly, but not unmanageable with a funnel in the reservoir and bottles of fluid open and waiting) When the fluid running out into the washing up bowl was no longer dirty I got the volunteer to stop the car, reconnected the return line, topped the fluid up to the correct level, started the car and spun the wheel lock to lock a couple more times, checked the level again and put the kettle on. Cheers |
The Following 2 Users Say Thank You to Bugjam1999 For This Useful Post: |
Oct 26th, 2021, 11:35 | #10 | |
Premier Member
Last Online: Today 10:45
Join Date: May 2012
Location: Lakenheath
|
Quote:
__________________
Cheers Dave Next Door to Top-Gun with a Honda CR-V & S Type Jag Volvo gone but not forgotten........ |
|
The Following User Says Thank You to Laird Scooby For This Useful Post: |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|