timing belt failure

[volvulus]

Hi, my 1991 940 2 litre died yesterday at a busy junction, there was no noise or drama that I could hear above the traffic noise but, after investigation the timing belt has snapped.

The burning question is..... is this engine, (I believe a B200f but could be wrong
a NON interference engine?

There are numerous threads I've seen on the web and, some say a red block engine is a safe, i.e. non interference engine and others saying their b200f had damage.

Is it a case of strip it and look or is there a definitive answer to interference or NON interference?

Many thanks Ken

[volvulus]

I should have said it's a non turbo engine.

I also should mention... I drove in reverse gear on the battery to get it onto the verge.

Ken

[Laird Scooby]

The B200F engine is, i believe, a borderline engine. Many say it's a non-interference engine but there have been others that have had valve to piston contact. However, in the majority of cases, those people also knew the head had previously been off and skimmed so reducing that vital valve to piston clearance.

Given that you were stopped at the time and hopefully only turned over on the starter, there's a fair chance you have got away with it - only way of being sure is to fit a new timing belt.

Are you sure it's a B200F? Is it mechanical or electronic injection and does it have a Lambda sensor and cat or not? A photo would help if you're not sure. If it's a B200E with K-Jetronic (mechanical) injection, there's a much higher chance of there being no damage.

[volvulus]

Originally Posted by Laird Scooby

The B200F engine is, i believe, a borderline engine. Many say it's a non-interference engine but there have been others that have had valve to piston contact. However, in the majority of cases, those people also knew the head had previously been off and skimmed so reducing that vital valve to piston clearance.

Given that you were stopped at the time and hopefully only turned over on the starter, there's a fair chance you have got away with it - only way of being sure is to fit a new timing belt.

Are you sure it's a B200F? Is it mechanical or electronic injection and does it have a Lambda sensor and cat or not? A photo would help if you're not sure. If it's a B200E with K-Jetronic (mechanical) injection, there's a much higher chance of there being no damage.

Thank you....it has a cat for sure.

ken

[Laird Scooby]

Originally Posted by volvulus

Thank you....it has a cat for sure.

ken

Probably is a B200F although the last of the B200E models were offered with a cat and Lambda as well but either way, we're back to a "suck it and see" of fit a new timing belt and hope.

[volvulus]

Originally Posted by Laird Scooby

Probably is a B200F although the last of the B200E models were offered with a cat and Lambda as well but either way, we're back to a "suck it and see" of fit a new timing belt and hope.

Thanks to all. I will get a belt and keep my fingers crossed.

I'll do a compression test after fitting.

many thanks to all Ken.

[rwdkev]

Originally Posted by Laird Scooby

Probably is a B200F although the last of the B200E models were offered with a cat and Lambda as well....

Are you sure about that Dave...?? My understanding is as below.....

https://www.volvoforums.org.uk/showthread.php?t=219949

[volvulus]

Originally Posted by volvulus

Thank you....it has a cat for sure.

ken

I was going about 35mph when I lost power, first thing I noticed was the oil light came up.

I tried jump starting it in gear then on the starter before I headed for the grass verge.

I want to avoid fitting a new belt to see if its damaged the engine. sort of throwing good money after bad, as much as I like my "tank", if it's a question of remedial work on the engine, i.e. valves, push rods, even a damaged piston then I would have to get rid.

kind regards ken

[griston64]

Originally Posted by volvulus

I was going about 35mph when I lost power, first thing I noticed was the oil light came up.

I tried jump starting it in gear then on the starter before I headed for the grass verge.

I want to avoid fitting a new belt to see if its damaged the engine. sort of throwing good money after bad, as much as I like my "tank", if it's a question of remedial work on the engine, i.e. valves, push rods, even a damaged piston then I would have to get rid.

kind regards ken

The belts are pretty cheap tbh

[baggy798]

It's game over, man, game over!

https://www.volvoforums.org.uk/showp...12&postcount=1

https://www.volvoforums.org.uk/showp...0&postcount=13

You might be lucky though.