|
PV, 120 (Amazon), 1800 General Forum for the Volvo PV, 120 and 1800 cars |
Information |
|
Ideas for mounting gaugesViews : 707 Replies : 4Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Mar 15th, 2024, 16:22 | #1 |
Junior Member
Last Online: Jun 17th, 2024 22:41
Join Date: Mar 2022
Location: Colorado
|
Ideas for mounting gauges
I'm looking for ideas where and how to mount gauges. Ideally I'm trying to avoid irreversible holes and cutting things up to install them. I already mounted oil pressure, water temp and volt gauges below the ashtray. I also purchased a tach and an air/fuel gauge I would like to mount.
I obviously wanted one of the Smiths 123 GT tachs but they are not easy to find. I found an Autometer tach in 2-3/8" size that looks somewhat similar but a little larger. I'm debating if I drill a hole in my dash and mount it like the 123 GT. I found a photo of it mounted near the door and that doesn't look bad. I'm thinking mounting the air/fuel gauge (2-1/16") either on the steering column or near the other gauges under the dash. I would like to hear ideas and see what other have done as far as location and mounting. Thanks |
Mar 26th, 2024, 19:18 | #2 |
Master Member
Last Online: Yesterday 17:14
Join Date: Dec 2001
Location: Stockport, Gtr Manchester
|
Here's where I put my tacho.
__________________
Mike Arnold. 1966 122S |
Mar 27th, 2024, 13:08 | #3 |
VOC Member
Last Online: Jun 22nd, 2024 14:01
Join Date: Jul 2006
Location: Chatham
|
This tach is neat and sensibly priced. With some though it could be mounted to the screen trim section that goes up the A post. Fit at the bottom close to the dash. That would save you drilling the dash pad if that is good with no splits. The air ratio gauge is overkill IMO. Finding the best position for the sender on the exhaust downpipe is rather hit or miss.
https://www.pepboys.com/sunpro-super...roduct/8345060 |
Mar 27th, 2024, 14:12 | #4 |
Premier Member
Last Online: Yesterday 15:30
Join Date: Jul 2007
Location: Connecticut, USA
|
CA;
I must agree with Derek...once adjusted, there is little need for constant monitoring of the A/F Ratio...it doesn't change as a rule, and if it did due to something inadvertently changing at the carbs, throttle response (or noises, or other indicators) would likely give us an indication and clue to check it out... I have located a Tach (actually an 1800 Smiths type) similar in location to that shown by Mike, at the right side of the instrument cluster: ...but on my LHD, this puts it more toward the center of the car, and line of sight, which I prefer...but again, a Tach is a "dress-up instrument", and not really a crucial instrument, unless you are going to be shifting at high revs repeatedly, and need to know RPMs accurately...after a short while, you will be shifting by the sounds from the engine compartment anyway... Cheers from Connecticut! |
Apr 4th, 2024, 15:23 | #5 |
Junior Member
Last Online: Jun 17th, 2024 22:41
Join Date: Mar 2022
Location: Colorado
|
Mike: That is the first time I have ever seen a dash/tach combo like that. Very cool but probably unobtainium.
I agree a tach is not necessarily needed but it's nice to have. I don't have any experience with an air fuel gauge but figured I would see what it's all about. I'm curious how the ratio will change with temperature and elevation. Where I live I can go between 10,000 ft and 6,000ft in a matter of 50 miles. Either way I have mounted the gauges in the 121. Nothing too creative, but also nothing intrusive if I want to remove them in the future. I mounted the 3 gauges in my 122 in the radio location since the dash was all butchered in that spot but didn't want to do that in the 121 just yet. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|