|
XC90 '02–'15 General Forum for the P2-platform XC90 model |
Information |
|
xc90 no rear wheel driveViews : 30187 Replies : 63Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Feb 12th, 2012, 22:45 | #41 |
New Member
Last Online: Sep 22nd, 2012 21:45
Join Date: Feb 2012
Location: Denbigh
|
Thanks Newbie1. I also tried pressing the menu button and the rear fog light switch - which I had read on here.....it brings up various acronyms I think - nothing appeared to be wrong, it just said 'dtsc set' etc.
|
Feb 13th, 2012, 17:17 | #42 |
Junior Member
Last Online: Sep 22nd, 2018 08:32
Join Date: Mar 2011
Location: sunderland
|
no awd
'dtsc set' means that there is a fault code stored on that module,it should be dtsc checking or dtsc ready that means there is no codes stored.for your awd do it again, and if you look for DEM as you go through the modules.if you get DEM checking or DEM ready you have no fault codes on awd system so poss mechanical ie spline sleeve.if you get DEM dtsc set you have codes or a code one the awd module i think if it has a code it will shut down the awd system so no damage can be done(i have read this on this forum)if you do have dtsc set then its to the dealer for codes to be read,or you need someone with a dice unit or a bsr ppc code reader/or eu702 code reader.these will read the modules for the awd system,any obd code readers only read engine codes not all modules,hope this helps so look for DEM that is the awd module.
|
Feb 13th, 2012, 19:34 | #43 |
Junior Member
Last Online: Dec 22nd, 2012 18:54
Join Date: Feb 2012
Location: salisbury
|
Dont forget the sleve that goes from the box to the angle drive wears!!
|
Feb 13th, 2012, 22:25 | #44 |
New Member
Last Online: Sep 22nd, 2012 21:45
Join Date: Feb 2012
Location: Denbigh
|
Thanks Newbie1 that's a big help. I did see other letters with 'set' after them, but I need to check again - I will do that tomorrow. I went under the car earlier and was able to turn the propshaft by hand - car was in neutral...engine off as you might imagine..! Should it turn when wheels are on the ground?
|
Feb 13th, 2012, 22:28 | #45 | |
Experienced Member
Last Online: Yesterday 23:51
Join Date: Jun 2007
Location: L/H side
|
Quote:
If the front is raised , then turning the propshaft will rotate the front wheels .
__________________
My comments are only based on my opinions and vast experience . |
|
The Following 2 Users Say Thank You to Clan For This Useful Post: |
Feb 14th, 2012, 20:45 | #46 |
Junior Member
Last Online: Sep 22nd, 2018 08:32
Join Date: Mar 2011
Location: sunderland
|
no awd
check your dtcs,if you have no codes it will be mechanical on the d5 ,if it is the spline sleeve. http://www.v70r.com/forums/index.php...27&#entry81927 look at this volvo forum for spline sleeve.i had simple task of removing a code and my awd back. i wish you lived local so i could put code reader on you car,i have little mechanical experience only 1st year city & guilds but have read so much about the awd problem i do feel i can give you some advice to help you on your way to poss solve the f+_%$£ problem. there is so may people out there that do not know they have no awd as no warning lights,and i feel so annoyed that they do not know, volvo should hold there heads low for such a class suv can be let down by poor quality and poss cause an road traffic collision due to no awd.
|
Feb 16th, 2012, 09:43 | #47 |
New Member
Last Online: Sep 22nd, 2012 21:45
Join Date: Feb 2012
Location: Denbigh
|
Thanks Newbie1 I appreciate your comments.
I have put the car into a shop as it's the easy albeit lazy option - for now. Going forwards I willl definitely investigate one of the code readers myself. Thanks again, |
Feb 16th, 2012, 19:03 | #48 |
Junior Member
Last Online: Sep 22nd, 2018 08:32
Join Date: Mar 2011
Location: sunderland
|
no awd
can you post what the shop says is wrong with your xc90 awd thanks
|
Feb 16th, 2012, 20:41 | #49 | |
VOC Member
Last Online: Feb 1st, 2023 11:27
Join Date: May 2007
Location: Rye, East Sussex
|
Quote:
__________________
1984 245 SE 1986 345 SE Auto 1991 940 TD Auto 2003 XC90 D5 SE AWD Geartronic2002 V70 D5 SE Auto 2014 V40 D2 SE Tiptronic Cross Country 2017 V40 D2 Cross Country Geartronic Pro 2015 XC60 D5 Polestar SE Lux Nav AWD Geartronic |
|
The Following User Says Thank You to RoyMacDonald For This Useful Post: |
Feb 17th, 2012, 07:35 | #50 |
2007/MY07 XC90 V8 Exec
|
Well now I'm worried that I don't have AWD...having only just purchased this 2nd hand 2007 (07 Plate) MY2007 XC90 V8 Auto...I get the following messages:
Checking DTCS...then DTCS in Vehicle...then underneath DTCS in Vehicle BCM DTC SET SAS Ready SRS Ready TCM Checking ECM Ready DEM DTC SET CEM DTC SET DIM Ready DDM Checking CCM DTC SET PDM Checking PSM Checking ICM Checking REM DTC SET PHM Ready UEM Ready HCM DTC SET Does this suggest plenty wrong...and in particular will I have no AWD as it reads DEM DTC SET? Appreciate any help out there, thank you? |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rear wheel wells | paul4be | 200 Series General | 4 | Dec 29th, 2005 20:38 |
brake and steering wheel judder on test drive | ex_lexus | S80 '98-'06 / S60 '00-'09 / V70 & XC70 '00-'07 General | 2 | Oct 14th, 2005 16:49 |
440 Rear Wheel Arch Repair | APS | 400 Series General | 7 | Sep 9th, 2005 20:05 |
Front wheel/rear wheel drive - I am confused!!! | grace7 | 400 Series General | 9 | Apr 5th, 2005 18:50 |
Rear wheel bearing | JohnL | 700/900 Series General | 2 | Apr 20th, 2004 12:58 |