|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
![]() |
|
Vac Pipe QuestionViews : 524 Replies : 5Users Viewing This Thread : |
![]() |
|
Thread Tools | Display Modes |
![]() |
#1 |
Master Member
Last Online: May 31st, 2024 20:27
Join Date: Mar 2012
Location: York/Selby
|
![]()
It appears that my pipes from the Vac reservoir were plumbed in incorrectly since getting the car. Only found out after a starting issdue and a new starter motor.
For anyone who can check, which of these looks correct? Single throttle body.
__________________
'08 V50 2.0D |
![]() |
![]() |
![]() |
#2 |
Premier Member
Last Online: Jun 22nd, 2024 06:47
Join Date: Apr 2013
Location: Plymouth
|
![]()
Hi
This is the Vac pipe layout for the twin throttle body. Assume just one valve and pipe is removed. Give you the general gist though.
__________________
V50 2005. 2.0D |
![]() |
![]() |
The Following User Says Thank You to IainG For This Useful Post: |
![]() |
#3 |
Master Member
Last Online: May 31st, 2024 20:27
Join Date: Mar 2012
Location: York/Selby
|
![]()
Many thanks, looks like the bottom one in my pic is correct then. Cheers
__________________
'08 V50 2.0D |
![]() |
![]() |
![]() |
#4 |
Premier Member
Last Online: Jun 22nd, 2024 06:47
Join Date: Apr 2013
Location: Plymouth
|
![]()
Hi
It is quite a simple system really but it just looks complicated when you just try and follow the pipes on the car without a diagram !!
__________________
V50 2005. 2.0D |
![]() |
![]() |
![]() |
#5 | |
Master Member
Last Online: May 31st, 2024 20:27
Join Date: Mar 2012
Location: York/Selby
|
![]() Quote:
But then today, the ruddy steering lock error popped up so I have that to sort too now.
__________________
'08 V50 2.0D |
|
![]() |
![]() |
![]() |
#6 |
New Member
Last Online: Jun 7th, 2024 12:22
Join Date: Mar 2019
Location: Beylikdüzü
|
![]()
TCV valve pipes become loose due to engine temperature. Install them in the correct place and ensure that they do not come off easily. I installed a smaller diameter pipe into the large expanding pipe and made a complete seal of approximately 3 cm. I think it worked.
|
![]() |
![]() |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|