|
PV, 120 (Amazon), 1800 General Forum for the Volvo PV, 120 and 1800 cars |
Information |
|
Gearbox rebuildViews : 2396 Replies : 14Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Oct 14th, 2021, 11:59 | #11 |
New Member
Last Online: Oct 16th, 2021 21:59
Join Date: Sep 2021
Location: Spa
|
Here is the little trick I made to the filler cap
F61BD6C4-5AD2-43F5-BA92-7C731AB9293D.jpg |
Oct 14th, 2021, 17:24 | #12 | |
Master Member
Last Online: Mar 26th, 2024 23:41
Join Date: Oct 2013
Location: Alberta
|
Quote:
|
|
Oct 14th, 2021, 20:13 | #13 | |
Senior Member
Last Online: Feb 25th, 2024 19:57
Join Date: Jan 2014
Location: stranraer
|
Quote:
|
|
Oct 15th, 2021, 18:41 | #14 |
New Member
Last Online: Oct 16th, 2021 21:59
Join Date: Sep 2021
Location: Spa
|
Hello, the other end reach the level with the original mark for the overdrive and I re-used the filler plug on the top of it. the "L" parts I used is from 1/2 inch plumbing connector with one end male and the other end female.
|
The Following User Says Thank You to Eric Jeunehomme For This Useful Post: |
Oct 17th, 2021, 09:36 | #15 |
New Member
Last Online: Feb 19th, 2024 00:35
Join Date: Jan 2021
Location: Burnaby
|
Suppliers sometimes incorrectly think bearings that are sealed or shielded are preferable. Recently I ordered a replacement for the input shaft bearing 6207 ZNR (shielded one side) what was sent was 6207 NR (no shield) which I suspect may permit excessive oil to flow into the cover and cause leakage at the seal.
Last edited by jgcoutts; Oct 17th, 2021 at 09:39. |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|