|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
EGR cleaner....??🙄Views : 477 Replies : 3Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Feb 2nd, 2021, 01:21 | #1 |
New Member
Last Online: Mar 14th, 2022 00:17
Join Date: Jul 2017
Location: Edinburgh
|
EGR cleaner....??🙄
I wonder if anyone could help??
I'm about to spray some egr cleaner into the air manifold of my V50 2.0D , without the hope of cleaning it up a bit( have a smokey acceleration issue) will it just clog my dpf.. I also had a suspicion that my crankcase pressure was the issue, is there an oil catch can or pcv valve I should check... |
Feb 2nd, 2021, 09:15 | #2 |
Member
|
What are you hoping to achieve with it? If it's cleaning the EGR I'd wager it won't. When my EGR began to block I removed it to clean and getting the oily soot off with a wire brush was a challenge. Ultimately, for me, all attempts to clean it failed and I had to replace it.
__________________
Present: 2009 Volvo V50 1.6D DRIVe SE Past: 2004 Volvo S40 T5 SE |
The Following 2 Users Say Thank You to iainmd For This Useful Post: |
Feb 2nd, 2021, 13:19 | #3 |
Member
Last Online: Jan 21st, 2023 17:15
Join Date: Aug 2020
Location: Ormskirk
|
If it's sufficiently funked up to cause issues then trying to clean in situ isn't going to work.
I would suggest removing the egr valve and cooler along with associated pipes and giving them a good soak in oven cleaner, rinse with boiling water from a kettle and repeat until acceptable. There's a few YouTube videos showing the process. |
The Following User Says Thank You to Wgl2020 For This Useful Post: |
Feb 3rd, 2021, 23:36 | #4 |
New Member
Last Online: Mar 14th, 2022 00:17
Join Date: Jul 2017
Location: Edinburgh
|
So I didn't use the aerosol, but chose to take off egr and clean it( wasn't stuck or too dirty) remove the throttle housing( not too bad either) .cleaned everything up!! Air intake on the other hand was very oily so cleaned as far as I could reach.
So my thoughts are a block in the PCV system/pipe/ valve... Has anyone got any tips on clearing it?? Would greatly appreciate a diagram |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|