|
C30 / S40 & V50 '04-'12 / C70 '06-'13 General Forum for the P1-platform C30 / S40 / V50 / C70 models |
Information |
|
Calibrating HCM in VidaViews : 637 Replies : 4Users Viewing This Thread : |
|
Thread Tools | Display Modes |
Jul 20th, 2023, 14:02 | #1 |
New Member
Last Online: Nov 16th, 2023 15:47
Join Date: Jun 2023
Location: Tallinn
|
Calibrating HCM in Vida
Hi!
Can anyone with a Vida and Dice confirm how the HCM position sensor calibration should look like? When I click "Calibration of position sensor", I immediately get a pop-up saying "Calibration executed", with start and exit buttons below. Clicking start doesn't change anything at all. Is this how it should be? I can't find any posts/videos of this procedure online. Any and all help is appreciated! Thanks! |
Jul 20th, 2023, 20:39 | #2 |
Premier Member
Last Online: Yesterday 23:54
Join Date: Mar 2017
Location: Manchester
|
hcm. im not familiar with that term what dose it relate to?
|
Jul 20th, 2023, 20:59 | #3 |
New Member
Last Online: Nov 16th, 2023 15:47
Join Date: Jun 2023
Location: Tallinn
|
Its the headlight control module. In my case I have the ABL (Active Bending Lights) xenons on my 08 v50 and after a series of events, they are pointing too low. But before you manually adjust them (of course the manual adjusters are broken) you should do it in vida. But im not sure if its working.
|
Jul 20th, 2023, 21:40 | #4 |
Premier Member
Last Online: Yesterday 23:54
Join Date: Mar 2017
Location: Manchester
|
is your headlight leveling motor working when the lights are turned on they should move up and down to calibrate the lights and compensate for any load level differences its not un common for these to fail .park against a wall to view if they are working. i can check ours with vida tomorrow .to find out
Last edited by Simmy; Jul 20th, 2023 at 21:44. |
Jul 21st, 2023, 05:58 | #5 |
New Member
Last Online: Nov 16th, 2023 15:47
Join Date: Jun 2023
Location: Tallinn
|
Yes thats working. It does the little side to side, down and up dance. Also no fault codes about that.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
Thread Tools | |
Display Modes | |
|
|