Quote:
Originally Posted by Salop Farmer
I have machined my rear drums to 229.1 ...
|
You may have over-done it (if only a little).
The direct link to the page I want to refer does not seem to work, but you can get to it by going to the index at:
http://www.networksvolvoniacs.org/in...rie:How_To%27s
and then go to section B and click on:
Bremse. Arbeiten an 1 – 2 und 2 mal 3 Kreisanlagen ..mit entlüften.,
It then takes you to the relevant page. About halfway down the page, for Daten Bremssysteme PV544 (Buckel), it says:
max permitted diameter 229 mm – if it is above that, replace.