The rubber expanding well nuts had been used because they accommodate thin sheet panels- they also have some allowance here for lining up etc.
Rust proof fittings & removable for me or the next owner being another priority.
Countersunk screws had initially been decided upon for appearances should the heads be partly exposed (yes painting the same also on the experimental agenda) it changed slightly as they do sink into the plastic trim covering but this isn't a problem.
The trim section is sealed top & bottom as notes but all areas have a protecting film of wax treatment applied to the main hidden sill areas.
The screws enter the trim at a central point exactly as the original fittings- the same is pulled into place evenly but firmer- some sealant is extruded but cleaned away forming a neat top & bottom seal.
Couple more pictures attached just prior to a final finishing of the sealed areas.
Bob.
|