So, I removed the old soldering I did on the appropriate pins and resoldered with fresh solder. Looks a bit better than before and learning to solder as I go along.
I took some readings on the module itself on the speed sensor pins. My multimeter was set to 2000k on the ohms setting this time. I wasn't getting any reading when it was set to 20K (on the ohm setting again) and guess it is out of range. I hope that is correct. I got the following readings:
LF sensor: pins 11 & 4 = 142.5
RF sensor: pins 18 & 3 = no reading at all (need to resolder these pins)
LR sensor: pins 10 & 2 = 80.6
RR sensor: pins 17 & 1 = 80.5
Do I multiply these readings by one thousand to get the proper results? I'm only learning to use a multimeter as I go along and not sure how to interpret the readings. Can someone with more knowledge tell me if the values are what they should be please? I read somewhere the sensors should read between 800 - 1300 ohms.
Many thanks in advance.
|