Quote:
Originally Posted by 360beast
That's a very tidy looking 940!
As others have said the LPT on runs 3.5psi so you probably won't even feel anything from it, it has the same power as the 2.3 non turbo but a bit extra torque.
Check the linkage from the wastegate actuator that goes to a pin on the back of the turbo (the wastegate) is actually connected as the R clip that holds them can fall out or get broken etc, quite a common problem which means the arm falls off so it makes no boost at all.
Finding a HPT actuator will be quite hard where as a £15 manual boost controller is readily available. To set the psi accurately you need a boost gauge, don't go for a cheap one as they aren't accurate at all.
They also have a T cam which means they run out of puff about 4500rpm and sap all the fun out of having a turbo petrol! I've fitted an IPD turbo cam and 531 head to mine and it happily revs to over 6k while still pulling hard and I'm sure if I let it then it would easily rev to 7k!
Seeing as it is a recently rebuilt engine I'd just give it a proper service, clean out the PCV system and if you want more power then fit a manual boost controller and if you want a wider power band then fit one of the following camshafts: A H K V VX3 VX or IPD turbo.
|
Thank you so much for the tips.
Let me ask you a question that might be stupid. I swear I looked on and out of the forum. But I'm having trouble finding shops where to buy parts. I know the USA forum has a list of them but most are in the USA or out of business. Is there such a list on this forum too? I can't, for the life of me, find it. I can find some shops on Google, but I'm sure there must be a thread discussing this. I just can't find it.
For example, where should I look for a good quality gauge or MBC?