[Janne100]

Hi,

I will get in touch with official vida and vdas(Lite).

Idea is to clone/programm new ECU, which will later be upgrade with vdas stage1.

Car is my2000 (P2) S80 with 2.5tdi (d5252t) and Bosch ECU.
CEM PIN should be open with vida somehow (car is too old to use vdash), and ECU pin should not be required for this model.

I have copied this from somewhere (maybe vdash page/forum), but I'm not sure what would be the correct sequence for operation.

"It is possible, but decoding CEM PIN is possible only if you read CEM flash on the bench or if you have access to official Volvo VIDA software upgrade.
After upgrade from Volvo VIDA just run VDASH on the same PC and it will decode PIN immediatelly and you can activate video in motion or anything else."


1. Connect computer to car and internet
2. Start vdash and connect to car
3. Start vida and connect
4. Start vida to update some module
... or what?

How to clone ECU, or should I download program from Volvo to new box?

.. related question? How to change DIM language with vdash? Cost?