Thanks for Video link Shade Tec. Had seen that in my looking for info. I should be able to remove discs without removing caliper carrier.
Removing the motor to wind the piston is my 3rd choice after DICE then 9 Volt battery.
1Monkey600
Ok I was half right. I can see now how the upper dome bit can be a boot and the connector releases at the base of the rectangle. I found a "flap" near the top of the rectangle, but as I was unsure then where the connector released, I did not push things when the connector did not immediately release.
Help on the Torx size would be greatly appreciated, as if T55 I can set a "large size" set with that size, without having to get a lot of bits set if the size was an odd ball size ie T57.
Cheers
Bob
|