Quote:
Originally Posted by ade555
I used Sealey CP2450 - Cordless Impact Wrench 24v 1/2"Sq Drive 410lb.ft and didn't have much of a problem, the reson why I recomended corded one was due to price, the cordless one is nearly £200, have a look on machine mart webside
http://www.machinemart.co.uk/shop/pr...-impact-wrench
Looking at the spec it should do the job 450nm
|
Maybe you were fortunate with your nut. I have done a few D5 cambelts and have struggled with the nut and have a very power powerful 1/2" drive air wrenches.
I have just done one and a 24" knuckle bar was with my entire strength would not undo it.
I ended up by passing all the safety devices and cut outs on my spare compressor and had to crank it to 225psi (not recommended or safe folks!!!) to undo the nut. Even then it took three attempts.