Quote:
Originally Posted by grainqey
take the drivers side rear seat upright out and take the rear bench out, you need two mole grips and two flat bladed screw drivers the turn the but splined nuts over the fuel pump and the sender on the passenger side, i made a special tool to prevent snapping the spline lugs off-not too hard to make but needs two 18mm square bars approx 100mm long and a flat plate etc welded onto the two bars to hold them the correct width
think the outside edges are 120/130mm across to fit in the splines
(it'll become clearer when you take the two silver plates off under the seats (4 10mm nuts to get each plate off)
HTH
alex
|
Are you saying to remove all the rear seats and the pump will be on the passengers side of the car.
Where exactly is the pump