V70 Headlight Washer Pump
Does anyone know where the blazes I can get a Volvo headlight high pressure pump? I have the old unit out and I have looked everywhere, eBay seems to have none and I cannot find them from any of the Volvo parts sites.
|
Try this previous post I came across. http://www.volvoforums.org.uk/showth...adlamp+washers
|
This looks very promising...
Ordered one, I will let you know how I get on with this - thanks. So for the record, the pump I have removed is a Valeo 89030971 Volvo 30699674. |
No worries. Best of luck. When you get round to replacing it could you do me a favour while you have your bumper off and measure the headlamp washers plastic pipe Inside diameter. As my 3way valve is goosed and I want to get a new one (non volvo) but don't want to take bumper off again to check pipe size.
Cheers. |
Quote:
Now wait a second, looking at the pump, which is sitting here, the output pipe OD is 7mm. I will check though, it may drop after it splits down into 2. |
1 Attachment(s)
I have the Ford Galaxy pump here, it is very similar.
To make it work I suspect I shall need to do the following: Shave a little lip off the edge of the electrical connector, but otherwise the shape of the socket and the terminals are identical. The output pipe has an O-ring and a push-fit connector type union. This makes the OD a bit bigger so the original pipe may or may not push over the top. If it doesn't I have 2 options, get another piece of pipe to make a reducer. Or carefully remove some material to reduce the size to accept the pipe. The body is marginally smaller so it may not be as tight a fit into the washer bottle as the original, but this can be solved with a couple of layers of electrical tape around the body to build it up a little. I am very confident this little pump will work just nicely. Attachment 96743 It's been a good morning for Volvo parts, my pump came, my 2 reluctor rings and my gearbox driveshaft seals! |
Fitted a Vauxhall pump and it is a snug fit no cutting
Paid Around £16 I think last year |
OK that is the pump in and working.
The plug went in fine, I took a TINY bit off the lip on the socket to get it to go all the way home and latch, it fit the tank tight and I fired it all up and had water spraying all over the ground, so brilliant - it has never worked since I owned the car. The pipe I will just force over the barb as I think that will work fine. |
To follow up:-
And the I/D of thick pipe leading to washer jets is?? Cheers |
Bumper comes back on Tuesday and I will look.
|
All times are GMT +1. The time now is 11:56. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.