Perishing Seal!
3 Attachment(s)
This applies to older non-240 older models too-
Newly acquired 1985 245, rained almost every day since bringing it home. The rear side windows are collecting moisture in the lower rear corners. I suspect, to some degree, this is part of the design. The problem is, water is penetrating the LH and there is a slight drip onto the panel covering the spare wheel. The seals probably need replacing. Question:- In the absence of new seals, does one: a) Use a proprietary sealant and attempt to stop water getting in? b) Let the water in but make sure it gets out? c) Does anyone have a miracle cure not covered above?! I thank you... |
I had this with mine many, many moons ago back in the eighties. Ideally a new seal, properly fitted, is the cure, but if none are available...
In my case I was only months from moving the car on, so I left it in the sun for a few days to dry out thoroughly and sealed it with Sikaflex EBT, which is a combined filler, sealer and bonding agent. If it's anything like mine was the leak was too much for a rubber compound such as Captain Tolley's to do the trick. Whatever you do don't use silicone sealant - as they cure they excrete H2O and acetic acid, both of which become trapped against metal and cause merry hell. My current 245 lives in a garage so I don't know if it is leaking there, no visible signs. Yet... |
Quote:
I would go with the proprietary sealant. Once it’s dry , of course. Warm sealant is , obviously, more penetrative. I made two Series Land Rovers leakproof using this method. The hollow section below the windows is susceptible to rotting out, I’ve seen this on earlier 245s. When dry , I’d get something sprayed in there too. I think it’s better to keep the water out mate!🧐👍 Echo the Sikaflex , definitely, not silicone . 👍 |
https://www.ebay.co.uk/itm/282386533...FYAAOSwFHBfyPr
This one is good:~ Non hardening butyl, warm the product for easier flow- area must be dry- clean up with white spirit. Bob. |
Quote:
|
Quote:
|
Having worked for Sika for 13 years (sadly no longer) I can testify that the range of Sikaflex sealants are excellent, most are polyurethane and some UV resistant.
One is elastomer, this is a non hardening sealant is excellent for use with existing seals, I used it to great effect when replacing the rear window(tailgate) on my 200TE many years ago. this can be used between the glass and rubber seal and between the seal and metal. |
Thanks
Thanks to all for the advice.
Sealant purchased and fine weather promised for next week.... |
Quote:
|
All times are GMT +1. The time now is 21:59. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.