Front parking sensor connector
 

I purchased a new front inner left parking sensor as mine had a fault on it. When I took the grill of I could see one of the cables in the plastic connector was damaged and disconnected. There was just enough left on the connector to blob abit solder on and do a temporary fix. Does anyone know where you can get those connectors from? Or, do you know how to get the current cables out of the connector?

P.s. any tips on how to get that grill with sensors in back in place without damaging the sensors on the bar direct behind? It's abit tricky

Any ideas?

The code for the connector is pa66-gf35.

Can't find much online for a replacement.

This is what the connector looks like

https://www.ebay.co.uk/itm/connector...-127635-2958-0

I'm not sure how similar the XC bumper removal is over the V, but I would remove the bumper for sure to do this properly. It's a few fastenings in the wheel arches each side and then some poppers in the centre and some clips in the middle underneath. It's a one person quick job to remove the fastenings, but I'd recommend a hand to pull the bumper off. It's not heavy just a little too wide to man handle it off with things still attached!