ECM-18B0 Swirl Actuator Control - Offset Fault
3 Attachment(s)
I wonder if anyone can help with the above fault on my 2008 XC90 D5 (185).
The fault is logged after an engine shutdown. If I clear it and drive, it's OK until shutdown. Looking at the live data, on shutdown, when the actuator goes to the end of it's travel, it reports 654% - which clearly isn't right. (Actuator seems to move normally otherwise). If I manually move the arm a tiny bit it jumps back to a sensible reading (under 100%). I've just replaced the swirl actuator with a used part, and it's exactly the same (might have been a few % different before, but certainly +600 something). I'm assuming the replacement part is also faulty, but before I take that up with the supplier, can anyone offer any suggestions? Previously the swirl flap assembly and arm etc were replaced, and they all work correctly. |
Did you ever resolve this problem?
I've got exactly the same thing happing on an XC60 with a D5244T4. |
All times are GMT +1. The time now is 07:53. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.