fault code p2008
 

Hi

Have got a emissions light showing on my 2005 v50 1.8 petrol. I had the codes read by a friend the code is p2008 I checked on the web bit can't find out what it might be any one got any ideas?

Thanks

I finally found out what this fault code is for.

Intake Manifold Runner Control Circuit/Open

Anyone replaced one? Can't seem to find any pictures or prices online.

S40 2005 1.8 Petrol
 

Hi there i've got an s40 2005 1.8petrol same issue same error code just happened today. Have you managed to get yours resolved?

Any information would be appreciated.

Cheers, Rich.

Yes it was the swirl control solenoids. Was done by the gar I got the car from under warranty so don't know the cost sorry

Hi thanks for coming back to me so quickly it's much appreciated - i'd found reference to that but mainly for diesel - good to know it solves it for petrol too. Thanks again.

Fix Code P2008
 

http://s17.postimg.org/rfradl60v/2005s4018petrol.jpg

Managed to fix this with a bit of carb cleaner £6 halfords and torque on Android to reset the code.

Basically remove the large pipe that goes between the air filter and the inlet manifold, once it's removed clean the inside of the inlet with carb cleaner mine wasn't too bad so I didn't remove the whole assembly. Reset the code and for me at least that solved it. Fingers crossed!!

Hope this helps someone.

Don't suppose you have a link to the bluetooth adapter you got for torque please

Hi mate the code is for the two solenoid valves (they come together ) that sit behind the hose you have removed the open the intake flaps that are internal within the intake manifold the valves have four vacuum hoses going to them the replacement parts are £55 so a cheap fix in my book?!

Here's the Bluetooth Adapter I purchased from Ebay that I used with Torque on Android to reset the code.

http://www.ebay.co.uk/itm/Google-And.../190869316819?

Good times then! Let's hope it lasts... Just in case it doesn't do you have the Part Numbers for the two solenoids?