Steering wheel puller - 120 series
 

Hallo, would anyone have a steering wheel puller, please?

No idea on the going rate but I would like to fit the Nardi I finally had splined.

Puller
 

Hi
I made a puller to remove my steering wheel, looking at your other post I would expect a 66 car to have the early wheel/horn ring. Mine is the later item with the butterfly shaped horn switch.
Its a simple puller made from sturdy flat bar with 2 x holes drilled at 34/35 mm centres. There are 2 bolts to pull the wheel included. Take a look at yours and if you think it will work I will post it. All I ask is that it is returned.
Regards,
Chris

Chris,

If anyone else can confirm this would work, Chris, I'll take you up on your offer.

If you remove the horn ring, 2 screws to rear of wheel spokes hold ring in place, if you see 2 threaded holes in the wheel at 34mm centres you should be fine.
I should be at Sywell hopefully next month and could bring it, though its not a big heavy item to post.
Chris.

Chris,

Aye, I had the horn ring off the other day.
Is the 34mm you speak of the diameter of the holes, or the distance between them?

The 2 holes are drilled 34mm apart when measured from the centre to centre of each hole.
The holes maybe 8mm.
Imagine if they were drilled 34mm there would be no steering wheel material left!