B18 Alternator position
Having blown the B18 engine in my 142 I have a fully rebuilt B18 from an Amazon to replace it. However I have discovered that the lugs which are cast into the block near the timing cover to which the lower alternator bracket attaches are not there. I understand that earlier Amazons had the dynamo on the left of the engine near the exhaust manifold. This would be an undesirable location for an alternator so I presume this was the reason to switch to the right of the engine. Is there a kit/modification available so that I can fit the alternator in the usual 140 position on the right? Many thanks
|
RC;
"...dynamo on the left of the engine near the exhaust manifold. This would be an undesirable location for an alternator so I presume this was the reason to switch to the right of the engine..." ...this location is no less desirable than the Dynamo/Generator location of the earlier cars...in fact, even the early RHD cars also had their Dynamo located on the Manifold side, so there must have been room (maybe it was just "tight")... but this begs the question: How was there room for the Dynamo, but not the Alt on RHD cars (which I cannot answer...maybe OD of a Dyn is less than OD of an Alt...someone with a RHD Amazon can chime in with some pix). I thought a major reason that the Alt was moved to the Distrib side was to clear the Steering Box on RHD chassis, but this was clearly not absolutely necessary...I accept the minor advantage of cooling. If you are going to use the B18 and must locate the Alt on the Distrib side, you will need a custom support bracket fabricated (I expect this might be involved and expensive)...but given the above with respect to there being adequate room on the Manifold side, an alternate solution would be to fit one of the retrofitted Alt brackets available (which add the Alt pivot to a similar location as shown below), onto the three OE Dynamo bracket holes. This might be a simpler, less costly solution than having the custom bracketry designed and fabricated for the Distrib side. ...hope that helps... https://www.sw-em.com/B18-20_Gen_Alt_mountings.jpg Source: https://www.sw-em.com/altkit_additio...n_B18_and_B20s Good Hunting! |
Hi, Thanks, I'me beginning to think I may have to go with the alternator on the manifold side, I believe I have heard of a kit being available to mount on the distributor side but having no success in finding one.
The alternator has a greater OD than a dynamo and also I believe that alternators are more likely to be damaged by heat soak than dynamos but I have no experience either way. |
Alternator
1 Attachment(s)
There is room for an alternator in place of the dynamo, a Lucas one fits a treat
(the wires aren't as close to the exhaust as they look in the photo). You can modify the existing bracket or use spacers and a suitable length bolt. I've had one in a similar position on a Triumph for years without any problems. There was a kit for the other side of the engine which uses a bracket that uses 3 of the timing cover bolts. |
1 Attachment(s)
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Quote:
|
Quote:
|
All times are GMT +1. The time now is 08:33. |
Powered by vBulletin
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.