|
Diesel Engines A forum dedicated to diesel engines fitted to Volvo cars. See the first post in this forum for a list of the diesel engines. |
Information |
|
ECM-26B0 Injector Power Signal too highViews : 10953 Replies : 24Users Viewing This Thread : |
|
Thread Tools | Display Modes |
May 20th, 2019, 21:25 | #11 |
Member
Last Online: May 27th, 2024 17:40
Join Date: May 2011
Location: East Cambs.
|
I think if you look at where Joe started and got to, he ended up replacing and splicing the new connectors on and had the same problem. Then pulled the loom cover off until he got further down and found those damaged wires. Wouldn't hurt for you to do the same in case it might be that simple.
__________________
2017 V60 D4 Geartronic |
May 22nd, 2019, 10:45 | #12 | |
Senior Member
Last Online: May 31st, 2024 14:57
Join Date: Dec 2002
Location: London
|
Quote:
In my case that almost solved the problem, the last part was getting the replacement (used) injector coded by Volvo. Hope you get it sorted, it is very frustrating with an intermittent problem like yours. Joe |
|
May 22nd, 2019, 20:10 | #13 |
New Member
Last Online: Oct 25th, 2020 07:08
Join Date: Jul 2011
Location: Manchester
|
Thanks for the reply. I've since removed the connector block from the ECU and cleaned the contacts with contact cleaner spray. While I was there I measured the resistance between the ECU connector block pins the injector plug pins and both read 0.15ohms which was the same reading as the plug on injector 2 so I assume that's normal? I did find a point where the main harness had been rubbing against the edge of the engine block, no wires are broken but one or two look a bit stretched so I'll investigate that further and as you suggested I'll check the whole length of the wiring harness.
At the moment it seemd to be pointing towards the injector though. I added some injector cleaner to the last tank of fuel (I know this isn't recommended and most of them are snake oil but I thought it was worth a try) and it may be coincidence but the issue seems to be a bit less frequent and the DTC code isn't being generated as often. On yesterday's commute I gave it a good revving once it had warmed up and after that it behaved itself for the rest of the journey. I'm inclined to leave it for a bit to see if it sorts itself out, if not I'll replace the injector. Did having the injector coded make any noticeable difference? I was quoted about £130 from a local dealer just to do the coding, I've read other posts where people have just swapped them over with no apparent issues. |
May 23rd, 2019, 18:22 | #14 |
Junior Member
Last Online: Dec 10th, 2020 20:59
Join Date: Feb 2019
Location: Teignmouth
|
I had something similar on my bmw 3 series 3.0 diesel a few years back. I used bmws software on my laptop to diagnose a misfire. Initially it said injector 5 not firing properly. So my first thought was faulty injector. I used the software more and dug deeper and got more info. The final message was resistance too high. When I checked the injection harness, the wires were all completely stiff. A new loom was only £45 so replaced it and it cured the problem and ran better than ever.
|
May 24th, 2019, 07:25 | #15 | |
Master Tech
Last Online: May 18th, 2020 10:57
Join Date: Dec 2006
Location: On Contract Dubai Automotve Technical Academy
|
Quote:
Best test on injector circuits is with an oscilloscope measuring voltage at the ECU and at the injector connector, that will show any loaded circuit dynamic voltage drop along with inductive current clamp to establish the amps flowing as low amps means circuit resistance if supply voltage is correct. |
|
Jan 20th, 2023, 17:37 | #16 |
Junior Member
Last Online: May 29th, 2023 12:31
Join Date: May 2010
Location: Aberdeen
|
Codes 26B0 etc
Just found this old thread and wonder if anyone can advise?
I'm getting occasional injector codes 2670, 2680 and 26B0 which are injectors 1, 2, 5. This thread says that's "injector signal too high", however my local Indy garage found a 26B0 reading and report it as "insufficient fuel pressure" (not a VIDA, but better than my basic code reader. I believe VIDA will identify which error when there are more options for a single overall code?) I've taken a first look at the injector wiring without as yet dismantling much, however, there is clear damage to some wiring (car is an XC70, D5 185, 2006, 144k miles). There's a wire that routes around the offside side of the oil filler cap and its conduit is badly cracked and broken, though the wires look ok for now (I have done a temporary fix). There are also some other injector feed wires I can see where they break out from the loom that have lost their covering. This all suggests that at the age and mileage I would do well to properly check all the injector wiring. So, questions: (I've never done much on this engine myself, and diesels are a bit of a mystery to me, however, I am reasonably competent, at least to know when to give up and get someone qualified to do it) 1. Which is cylinder 1 - nearside or offside? This seems to be so obvious that nowhere on the net or the Haynes manual does it say. AFAICT, no.1 is offside, left as you look at it standing in front of the car 2. Am I right that to get at the injector wiring (mostly behind the engine?) the sequence is: disconnect battery, remove engine top cover, remove transverse strut (both ends and a connection to the cyl head, then remove the plastic cover above the injectors (into which the top cover hinges) with two nuts either end at the front and twomdown the back of it)? 3. And finally, could water in the fuel cause these codes? The local filling station we use has been out of action, many cars locally reported by our Indy garage with water in the fuel, including my wife's XC60 D5. I have had the fuel filter changed, codes cleared and will see if they come back. My feeling is it's not this, but dodgy wiring. Thx in advance |
Jan 21st, 2023, 00:24 | #17 |
Premier Member
Last Online: Jun 2nd, 2024 22:52
Join Date: Oct 2011
Location: Groningen
|
1 if you stand in front of the car left is 1 and right is 5
2 correct 3 this is electricly related ...injectorcoil, wiring or the amplifier in the ecm Most suspect is the wiring. I also suspect that bad earthing will cause or worsen this How is the car starting under different temperatures? good idling? Last edited by 5cilinder; Jan 21st, 2023 at 00:27. |
The Following User Says Thank You to 5cilinder For This Useful Post: |
Jan 21st, 2023, 10:32 | #18 | |
Junior Member
Last Online: May 29th, 2023 12:31
Join Date: May 2010
Location: Aberdeen
|
Quote:
3. Starts fine, regardless of hot or cold. Idles ok. You'd basically never know from its running that there are any codes up. I do get the very occasional momentary loss of power, a bit like an unsmooth gear change on the auto, but I think it's perhaps a very short misfire. This I could easily put down to a slug of water coming through, hence fuel filter change and a wait and see, though the garage didn't find any collected in the filter (unlike my wife's car, which had lots). Will check the earthing, but what I can see has no corrosion/crystallisation at all. I recently had a Bosch service centre check the vehicle when it wasn't running right, they found nothing, having checked all the wiring end to end and thought it could be the ECU. Those codes mostly went away when I asked for the Air Mass Meter to be changed, but left these injector codes, so I suspect the AMFM and these injector codes are different issues. At present, clearly intermittent, the hardest type to find. Thanks again |
|
Jan 21st, 2023, 11:24 | #19 | |
Premier Member
Last Online: Jun 2nd, 2024 22:52
Join Date: Oct 2011
Location: Groningen
|
Quote:
|
|
The Following User Says Thank You to 5cilinder For This Useful Post: |
Jan 21st, 2023, 15:35 | #20 |
Junior Member
Last Online: May 29th, 2023 12:31
Join Date: May 2010
Location: Aberdeen
|
Thanks. As I want to keep the car, thinking of getting it to an Indy Volvo garage to give it a good going over, it's a 100 mile drive but he has a good reputation.
|
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|